Are you a cnc beginner looking for project ideas? In this project, you’ll see me use my Onefinity CNC Woodworker X50 to build a black walnut serving tray using a 3/4 inch bowl bit and a 1/4 inch downcut bit. Watch this video through to learn from my mistakes.
A perfect project in the CNC for dummies category, and better yet, you can see Part 1 of this project below, where you’ll learn how to use VCarve Pro to design this catchall tray.
See Part 1, designing this project with VCarve Pro – https://youtu.be/qdJhI_Tm61Y
Products and Equipment Used
Onefinity CNC Store – https://www.onefinitycnc.com/cnc-machines
Odie’s Oil Starter Kit – https://amzn.to/3UTpq2n
Makita Palm Router – https://amzn.to/3qNuvfi
CA Glue and Accelerator 4 Pack – https://amzn.to/3SdnfW0
WEN Spindle Sander – https://amzn.to/3Ti4GQn
Rubber Gloves – https://amzn.to/3zWp2bc
¾ Inch Bowl Bit – https://amzn.to/3Ee23en
¼ Inch Endmill Bit – https://amzn.to/3UuGThq
Dewalt 734 Planer – https://amzn.to/3zUIjtq
Sanding Discs – https://amzn.to/3NNz0RU
00:00 Introduction
01:10 Planing Rough Lumber
01:31 Cutting On The Onefinity
05:54 Lord Of The Dance
08:47 Sanding
10:23 Finish With Odie’s Oil
11:45 What Would I Change?
source
Comments are closed.