Shelves, doors, cabinets, and even latches all make from native red cedar, and dressed up with some relief and v-carving done on Seekers home built CNC machine. Many thank to Lorenzo for getting the CNC up and running.
Mach3 Wireless Handwheel Controller: https://amzn.to/2Xt7Ibc
Stick On Neodymium Bar Magnets: https://amzn.to/2V74U2d
Screw On Neodymium Bar Magnets: https://amzn.to/2K0nWRf
Screw On Neodymium Round Magnets: https://amzn.to/3b6u1r8
DeWalt Benchtop Planer: https://amzn.to/2RzCuvn
Stainless Steel Piano Hinge: https://amzn.to/2K1a49m
Jabsco Manual Marine Toilet: https://amzn.to/2VmjEsF
2P-10 Thick Glue and Activator: https://amzn.to/3b2Xn9W
“CNC Table Auto Level with G-Code Ripper for Perfect V-Bit Carving”
G-Code Ripper: www.scorchworks.com/Gcoderipper/gcoderipper.html
NOTE: We have not had any success running G-Code Ripper code using interface controllers that use a USB connection. We have not had any problems when using a parallel port connection between the computer and the controller interface. Here are two that have worked for us: GeckoDrive G540, but it’s very expensive https://amzn.to/3fz5oGd. Or a very cheap Chinese controller: https://amzn.to/2T6Ri5F Both worked fine. The trick I think is to avoid anything using a USB connection.
[ Support Seeker ]
Patrons and Other Support: http://wp.me/P6ivyU-1wT
Buy Anything on Amazon and support Seeker when you use this link: https://amzn.to/2PeHRfq
[ Shop ]
Seeker Junk Store: http://www.svseeker.com/wp/sv-seeker-2/shop/
Junk Store on Amazon http://www.amazon.com/shop/svseeker
[ More ]
Volunteer https://goo.gl/Lo1p6y
About Us: http://www.svseeker.com/wp/sv-seeker-2/about-us/
FaceBook Page: https://www.facebook.com/SailingVesselSeeker/
FaceBook Group https://www.facebook.com/groups/svseeker/
Blog: http://www.svseeker.com/wp/blog/
source
Comments are closed.