The CNC machine electrical wiring is complete! This week I finished all the panel wiring for the Centroid Acorn – Dyna Myte 2800 CNC retrofit. This included adding circuit breakers to the 24 Volt power circuits, wiring the interface cable between the DYN4 AC servo drive and the Acorn controller & adding a contactor and AC line filter to the servo drive.
I also cleaned up and repainted the electrical enclosure and got everything mounted back on the Dyna Myte 2800. I then go over the decisions I made regarding the electrical panel layout and discuss all the connections to the Centroid Ether1616, Centroid Acorn, the Gecko G251X stepper drives and the DMMM Dyn4 Servo Drive.
Finally, I go over what is left to do to complete this project. Very productive week and I’m quite pleased and surprised by how well this turned out.
? Subscribe! https://www.youtube.com/PeteRondeau?sub_confirmation=1
As an Amazon Associate I earn from qualifying purchases.
(paid links)
Ferrule Crimper: https://amzn.to/2XWvZGV
Ferrule Assortment: https://amzn.to/2ziTG1P
Vice Grip Wire Stripper: https://amzn.to/2xFQ89H
Terminal Block Assortment: https://amzn.to/2VQdMrZ
Wire Duct: https://amzn.to/2Y4Ihgm
Purple Power De-greaser: https://amzn.to/2VNM9zT
Centroid Acorn: https://amzn.to/2x1x8lF
Gecko G251X https://amzn.to/2zotmnb
63A Contactor: https://amzn.to/2VM0ywm
————————————————————————————————————————————————–
Want to swap stickers? contact me at: [email protected]
—————————————————————————————————————————————————
#CentroidAcorn #DMMServo #GeckoDrive
source
Comments are closed.