So I made a 3d printed coin for my buddy (Electrocuted Electrician) a long time ago, and it finally broke. He asked is I could make him a new one… So hey, why not upgrade it to aluminum now that I can?!
Coin diameter: 36mm
And I figured out chapters too!
00:00 Intro
04:00 Tool change and setting the tool
05:50 Diamond drag tool
06:56 This is were I goofed (Put in wrong tool)
08:10 I flipped the part over keeping everything referenced with the pins
Note: I’m new to video editing, and editing in 4k is pretty slow on my machine. I don’t have enough time right now to make it any fancier. Tis the season eh?! (i7-7700k, GTX1080 and 32Gb)
– I may downgrade the videos to 1080 for now to make it a little quicker and easier till I can afford an upgrade.
source
Comments are closed.